Led Tail Light Overview / Service; Led Taillight Removal; Led Taillight Installation - Polaris 850 MATRYX INDY XC 129 2021 Manual

LED TAIL LIGHT OVERVIEW / SERVICE

The tail / brake light is a sealed assembly and not
serviceable. There are 10 LEDs
Both the tail and brake circuits are powered by the RD/
WH DC chassis voltage circuit. The tail lamp is always
illuminated when the engine is running.
The brake light circuit is protected by a 2 AMP fuse. This
circuit is closed when the brake lever is pulled. If the fuse
is blown, there is a short in this circuit.

LED TAILLIGHT REMOVAL

1. Remove the two fasteners
assembly.
9850064 R03 - 2021 650 / 850 Matryx Trail Performance / Crossover Snowmobile Service Manual
© Copyright Polaris Inc.
q
on the circuit board.
q
securing the taillight
BATTERY / ELECTRICAL
2. Carefully pull the taillight assembly forward and
disconnect the taillight connector
e
taillight assembly .

LED TAILLIGHT INSTALLATION

1. Position the taillight near its installed position and
connect the taillight connector
e
assembly .
w
. Remove the
w
to the taillight
10
10.63