Connections - Teac CR-L600 Owner's Manual

B
SUB WOOFER
A
B
10
A
SPEAKER

Connections (1)

CAUTION
Turn off the power of all the equipment before making
connections.
Read instructions of each component you intend to use
with this unit.
< Be sure to insert each plug securely. To prevent hum
and noise, do not bundle the connection cords with the
power cord or speaker cord.
A Speaker Connections
Caution:
To avoid damaging the speakers by inputting a sudden
high-level signal, be sure to switch the power off before
connecting the speakers.
< The amplifier's red speaker terminals are the +
(positive) terminals and the black terminals are the _
(negative) terminals.
The + side of the speaker cable is marked to make it
distinguishable from the negative side of the cable.
Connect this marked side to the red + terminal and the
unmarked side to the black _ terminal.
< Prepare the speaker cords for connection by stripping
off approximately 10 mm or less (no more as this could
cause a short-circuit) of the outer insulation.
Twist the wires tightly together to avoid tangles :
B SUBWOOFER OUT jack
Connect a commercially available powered subwoofer.
> Subwoofer output will not be cut off, when the
headphone jack is inserted.
How to connect
1
Turn the terminal cap counterclockwise to loosen it. The
speaker terminal caps cannot be fully removed from the
base.
2 Insert the wire into the terminal fully and turn the
terminal cap clockwise to securely connect it :
3 Make sure it is fastened firm by pulling the cable
lightly.
ENGLISH
A
B