Installation In Dashboard; Wiring Connections; Hardware - Teac TE-605s User Manual

Mounting Strap
Bolt
Screw
ISO Cable

Installation in Dashboard

If your car is fitted with a one (1x) DIN size opening for a car audio system, you can install the Car Radio
according these steps.
Note: Unit should be installed horizontally in an angle less than 30°.
1X DIN SLOT
1) Insert the mounting bracket into the 1X DIN opening of your dashboard.
2) Bend the mounting tabs outwards with a screwdriver, to tighten and fix the mounting bracket in its place.
3) Connect the M5 Bolt to the rear of the unit.
4) Check electrical connections as described earlier (either an ISO connection or separate wiring)
5) Insert the ISO connector into the unit.
6) Push the unit into the mounting bracket until you hear a click
7) Move the assemble bar (metal strip with holes) over the M5 bolt. And use the M5 nut to tighten the
assemble bar.
8) Use the screw Bt5x20 to fix the other side of the assemble bar to the car body.
9) Place the front rim over the unit to finish the installation.

Wiring Connections

Note: Never connect cable to the system while it is connected to the battery power. Whenever the unit is
disconnected from the battery, the preset memory will be erased and the unit will go back to its factory
defaults.
1
1
1
1
Screw 4
key 2
sleeve 1
Manual 1