Table of Contents
Advertisement
OPC9000 series − Instruction manual v1.0
10.5.2
Installation
•
For modules in their original packaging:
Remove the ESD protective cardboard packaging.
Never touch the contacts!
Move the pull-out tab to a middle position.
•
•
Insert the module so that the contacts point towards
the circuit board.
Lower the module approx. 5 mm from the edge of the
•
housing so that the metal brackets come to rest in
the recesses in the circuit board.
FYI: Section 10.5.3 shows how the metal brackets are
inserted into the circuit board.
•
Push the module in all the way with a slight pressure.
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
40
Advertisement
Table of Contents
