OPC9000 series − Instruction manual v1.0
7.9 Wake on LAN (WoL)
This function can be used for event-driven start-up of "sleeping" computers on the local network, such
as for running updates at night.
The interfaces LAN1 ... LAN 3 are available for this purpose:
The computer must be in one of the following ACPI states
−
State S5: computer is shut down, voltage is present
State S3: energy-saving ("sleep") state
−
State S4: hibernate state
−
*) Advanced Configuration and Power Interface
7.9.1 Settings in BIOS
The following setting must be active to enable the use of WoL:
In the standard BIOS (press the [Del] key several times when starting):
−
ads-tec Settings / LAN1 (i219) Wake on LAN Enable / Enabled
If the network stack has been activated, the following settings are also required:
−
ads-tec Settings / Intel® I210 Gigabit Network Connection [MAC1] / NIC Configuration /
Wake on LAN: Enabled
ads-tec Settings / Intel® I210 Gigabit Network Connection [MAC2] / NIC Configuration /
−
Wake on LAN: Enabled
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
in order to wake up via WoL:
*)
31