OPC9000 series − Instruction manual v1.0
10.4 Installing or removing SSD cards
Format: SSD cards with the format M.2 2242 Key M can be used.
Interface: depending on the slot, SATA or NVMe cards can be used (see figure below).
Compatible mass storage cards can be obtained from ADS-TEC if required.
Removal:
1. Pull off the service slot cover as specified in section 10.2.
2. Remove the retaining screw, lift the SSD card slightly and pull it out.
Installation:
1. Insert the new card into the slot from above at a slanting angle.
2. Press the card down and fix it with the screw (M3x6) provided.
SATA / NVMe
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
SATA
38