Table of Contents
Advertisement
OPC9000 series − Instruction manual v1.0
10 Maintenance
ATTENTION
Personal injuries and damage to property through improper use
All installation and service work performed on the device must be performed only under safe,
secure and de-energised conditions!
ATTENTION
Damage to the device due to electrostatic discharges
Always adhere to the safety measures applicable when handling components at risk of being
damaged by electrostatic discharges in accordance with EN 61340-5-1/-2.
10.1 Removing the device
ATTENTION
Depending on the installation situation, have a person hold the front of the device, if needed to
prevent it from falling down after the clamps are loosened.
1. Loosen the clamping screws by turning counter-
clockwise (5 mm hex socket).
2. Push the clamps completely into the housing
against the spring pressure.
3. Tighten the clamping screws counter-clockwise
as far as they will go, so that the clamps are
fixed in the housing and do not prevent the
device from being removed from the wall recess.
4. Remove device from the wall recess.
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
35
Advertisement
Table of Contents
