Table of Contents
Advertisement
Usage instructions SPEEDY F4 & F2
To open the brake, press the front part of the
control element towards the middle of the
wheelchair (away from the wheel).
Press the front part of
the control element to
the inside
Figure 156: Integral brake closed, the brake is
opened by pressing the control element towards the
middle of the wheelchair
When opening and closing the brakes,
make sure that the control and brake element
are never grasped. Press the brake only using
one finger or with the ball of your hand on the
front part of the control element.
25.3.2 Brake adjustment with standard
installation
The following instructions are intended
for and may only be carried out by a rehabilita-
tion specialist dealer or PRO ACTIV
Settings on the brake could be necessary for
the following reasons:
You have changed the tyre or the tyre
pressure.
You have changed the wheel tracking or
the position of the drive wheels.
The brake is pulling unevenly or insuffi-
ciently after extended use.
To adjust the integral brake with standard in-
stallation (Ergo models), proceed as follows on
both sides:
1. Initial situation: Drive wheels mounted on
the product and the integral brakes open.
The drive wheels have the specified infla-
tion pressure.
2. Slightly loosen the M5 clamp screws (AF
4 mm) so that the brake mount can be
moved on the hexagon rail.
Hexagon rail
Figure 157: Hexagon rail and brake mount
M5 clamp screws
Figure 158: M5 clamp screws for
positioning the integral brake (view from inner side
of product)
3. Press the front part of the control element
to the right or left outwards until the brake
element rests against the tyre. Do not
close the brake completely.
Brake mount
54
Advertisement
Table of Contents
