Removal And Attachment Of The Clothing Guard - ProActiv SPEEDY F4 Usage Instructions

Hide thumbs Also See for SPEEDY F4:
Table of Contents

Advertisement

Side panel guide
Locking pin
Figure 42: Locking pin engages in the locking hole
in the side part (shown without clothing guard and
equipped with an integrated brake)
Side panel guide
Locking pin
Figure 43: Locking pin engages in the locking hole
in the side part (shown without clothing guard and
equipped with an knee-lever brake)
Figure 44: Locking pin engaged in the mounting bar
of the clothing guard (view with clothing guard)
23
Locking pin
engaged in the
mounting bar
Usage instructions SPEEDY F4 and F2
20.3.2 Removal and attachment of the
clothing guard
The locking pins must first be released to re-
move the clothing guard. For this purpose,
grasp under the seat cover and in the middle,
pull the cord to the front that is linked to the
locking pin and keep it in this position.
Locking pin
Figure 45: Locking pin connected to a cord (view
from inner side of product)
Cord
Pull from the
middle to
the front
Figure 46: Cord for pulling the locking pin
Observe: In case you are sitting in the
product when removing the clothing guard, you
have to relieve the backrest before pulling the
cord.
Now, first the clothing guard can be removed
from the side panel guide for the mounting bar
(then the cord can be released again) and
pulled from behind the back joint shaft.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Speedy f2

Table of Contents