Table of Contents
Advertisement
Usage instructions SPEEDY F4 & F2
18 Back system
Avoid falling into the seating and backrest
upholstery/back shell as it significantly in-
creases the risk of an adjustment, falling down
or defects.
18.1 Backrest angle
18.1.1 Adjustment possibilities with
backrests fixed by being bolted on-
to side panels
The following instructions are intended
for and may only be carried out by a rehabilita-
tion specialist dealer or PRO ACTIV
With backrests screwed permanently onto side
panels, there are no possibilities for flexible
backrest adjustment without tools available.
Figure 4: Backrest screwed permanently onto side
panels, equipped with Carbon side parts with inte-
grated clothing guard
However, permanent adjustment of the
backrest 5° forwards or backwards is possible
using tools if the product is equipped accord-
ingly.
with an "Aluminium side panel", or
with an "Aluminium side panel with
screwed on clothing guard", or
with an "Aluminium side panel with inte-
grated clothing guard".
For this, there are three holes in the rear area
of the side panel at the top and an elongated
hole at the bottom to position the backrest
tubes. To adjust the backrest 5° forwards or
backwards, loosen both M5 fixing screws
(AF 3 mm) with washers on each side and
position the fixing screws with washers in the
desired holes of the side panel at the top and
bottom in the corresponding position in the
elongated hole (same position on the right and
left). Then tighten up the M5 fixing screws
(AF 3 mm) again to 6 Nm and secure them
with thread lock fluid.
Three holes at the top
and elongated hole at
the bottom for adjusting
the backrest position
Figure 5: Adjusting the backrest position using holes
in the side panel or the clothing guard
18.1.2 Adjustment possibilities with an
adjustable backrest
If equipped with an adjustable and foldable
backrest, the backrest angle can be flexibly
adjusted without using tools and the backrest
can be completely folded away. The angle of
the backrest can be fixed in 7 positions in 5°
steps.
Observe that the centre of gravity is shift-
ed further to the rear by the enlargement of the
angle between the backrest and the seat sys-
tem and thus, the tipping point of the product is
reached much sooner.
M5 fixing screws
with washers
14
Advertisement
Table of Contents
