Table of Contents
Advertisement
26 Push handles
26.1 Back tube with integrated handles
Figure 168: Back tube with integrated handles
With these push handles, there is no option for
adjustment and no possibility to remove the
handle.
26.2 Aluminium push handles fixed in
back tube
Figure 169: Aluminium push handles fixed in back
tube
It is not possible to adjust these push handles.
To remove the push handles, undo the M6
fixing screw (AF 4 mm) with washer on both
sides. The push handles can then be pulled
out from the back tubes.
To install the push handles, place these in the
back tube and insert the M6 fixing screws (AF
4 mm) (with washers) into the each of the
holes of the back tube and push handle. Tight-
57
M6 fixing screw
with washer
Usage instructions SPEEDY F4 and F2
en the M6 fixing screws (AF 4 mm) to 11 Nm
torque and secure them with thread lock fluid.
26.3 Push handles, horizontally
screwed in back tube
Figure 170: Push handles, horizontally screwed in
back tube
It is not possible to adjust these push handles.
To remove the push handles, turn these coun-
ter-clockwise out of the back tube.
Screwing out
Figure 171: Screw the push handle horizontally out
of the back tube
To install the push handle, turn it into the back
tube clockwise and tighten it to a maximum
hand tightness.
Advertisement
Table of Contents
