Footrest Continuous; Footrest Folding Up To One Side - ProActiv SPEEDY F4 Usage Instructions

23.2 Footrest continuous

Figure 101: Footrest continuous
For the longitudinal setting of the footrest
support tubes or adaptation to the lower leg
length, the M6 fixing screws (AF 4 mm) must
be undone on both sides on the outside of the
frame tube. The footrest support tubes are
then pushed along their slots and thus brought
into the correct position. Observe that the foot-
rest support tubes are both the same length on
both sides after they have been adjusted.
Slots in the
support tube
Figure 102: M6 fixing screw with washer and slot in
footrest support tube for adjusting the lower leg
length
Once the position has been set, fix the footrest
support tubes by tightening the M6 fixing
screws (AF 4 mm) with washers to 11 Nm on
both sides.
39
M6 fixing screw
with washer
Usage instructions SPEEDY F4 and F2
Note:
With a V-shaped product frame or with a larger
lower leg width at the top than the bottom, it is
necessary to relieve the footrest support tube
tension in the footrest support plate resulting
from longitudinal adjustment. In this case, the
M6 fastening clamp screws (AF 5 mm) on the
footrest support plate therefore have to be
opened before starting to adjust the lower leg
length. View the procedure in chapter 23.1.

23.3 Footrest folding up to one side

Figure 103: Footrest folding up to one side, stand-
ard position
For footrest folding up to one side, lift the
footplate support up in the direction of travel on
the left side.
Footplate support
Figure 104: For folding up to one side, lift the foot-
rest up in the direction of travel on the left side
(product view from the front)