Table of Contents
Advertisement
25.2 Knee lever brake with pull cable
operation (SPEEDY F2)
Figure 144: Knee lever brake with pull cable opera-
tion, control unit
Figure 145: Knee lever brake with pull cable opera-
tion, braking unit
25.2.1 Opening and closing the brake
The brake is closed by pushing the brake
lever forwards and downwards. In the closed
position, the brake pin pushes the tyre in by
approx. 4 mm (at the specified air pressure in
the tyre).
Brake lever
Figure 146: Brake opened, closed by pushing the
brake lever forwards and downwards
51
Close brake
Usage instructions SPEEDY F4 and F2
Figure 147: Brake closed, brake pin presses into the
tyre by approx. 4 mm
Please note that the knee lever brake
with pull cable operation is a parking brake
which may only be applied when the product is
at a standstill. This is not a service brake which
is suitable for reducing speed.
To open the brake, pull the brake lever back
up and rearwards again. In the open position,
the distance between the brake pin and the
tyre is approx. 3 to maximum of 4 mm.
Figure 148: Brake closed; opening done by pulling
the brake lever up and rearwards
Open brake
Advertisement
Table of Contents
