Table of Contents
Advertisement
Usage instructions SPEEDY F4 & F2
Figure 47: Clothing guard pulled from the side panel
guide to the front (shown without drive wheel)
To mount the clothing guard, this is first
connected to the rear of the back joint shaft
with the mounting bar, then the mounting bar is
inserted at the front in the side panel guide and
pressed downwards until the locking pin en-
gages in the mounting bar.
Figure 48: Mounting bar pinned on the back jointed
shaft (shown without drive wheel)
20.3.3 Adjusting the clothing guard posi-
tion
The following instructions are intended
for and may only be carried out by a rehabilita-
tion specialist dealer or PRO ACTIV
After changing to different tyres, the clothing
guard position may need to be adjusted to suit
the wheel arch. The distance between the
tyres and the clothing guard should be be-
tween 5 and 8 mm to avoid pinching your fin-
gers, scraping the tyres on the clothing guard,
and obstruction when grasping the handrim.
To adjust the clothing guard position, loosen
the two M5 fixing screws (AF 3 mm) from the
clothing guard mount on each of the clothing
protection guards.
Clothing guard mount
Figure 49: Clothing guard mount
M5 fixing screws
Slots of the
mounting bar
Figure 50: M5 fixing screws and slots on the mount-
ing bar
Now the mounting bar can be brought into
position using the slots of the clothing guard
and the mounting bar.
Finally the clothing guard mounts are posi-
tioned accordingly and the M5 fixing screws
(AF 3 mm) are screwed back into the clothing
guard mounts with 6 Nm.
24
Advertisement
Table of Contents
