Table of Contents
Advertisement
7.
On the Resources tab, scroll down and expand the Software, firmware, and applications section link to
download the Power Xpert Gateway USB Signed Windows Device Driver.
8.
Save the driver configuration file (px-ups-signed-driver.zip) to the C: drive using the default location or a
folder you select. Note the path of the downloaded file on your computer.
NOTE
C C o o n n n n e e c c t t t t h h e e C C a a r r d d t t o o t t h h e e C C o o m m p p u u t t e e r r
To connect the card to the computer:
1.
Plug the small connector at the end of the supplied USB configuration cable into the Setup port on the
card (see
Figure 3. Install the USB Cable
2.
Plug the other end of the USB cable into the USB port on the computer. The Windows operating system
detects new hardware.
NOTE
NOTE
3.
Connect an active Ethernet cable (not supplied) to the Upstream Ethernet connector on the PXGX UPS
card (see
4.
If you are connecting to another PXGX UPS card or other Ethernet device, connect an Ethernet cable (not
supplied) to the Downstream Ethernet connector on the PXGX UPS card.
Do not download the file to your desktop.
Figure
3).
If a message indicates that the device driver software was not successfully installed,
click Ignore.
You may see a pop-up message window that shows "Found new hardware." This
indicates that the hardware installed successfully.
Figure
4).
Eaton Power Xpert® Gateway PXGX UPS Card Quick Start Instructions 164950240—Rev 04
Connect the Card to the Computer
3
Advertisement
Table of Contents
