Install The Driver Software - Eaton Power Xpert Quick Start Instructions

Install the Driver Software

Figure 4. Install the Ethernet Cable
5. Wait for the power light and status light on the installed card to illuminate. This takes about two minutes.
6. Open a Web browser and type the default IP address (https://169.254.0.101 for firmware 2.6.0.0 or later,
http://192.168.200.101 for earlier firmware versions).
7. Did the Power Xpert Gateway software open to the PXGX UPS card page?
• If yes, the driver has already been installed automatically. Either verify the IP address assigned
through DHCP or manually enter a static (fixed) IP address for the card's network connection:
a.
b.
• If no, the driver has not been installed. Go to the
have the most current USB Driver software. If not, install or update the USB Driver software.
I I n n s s t t a a l l l l t t h h e e D D r r i i v v e e r r S S o o f f t t w w a a r r e e
The steps you use to install the driver software depend on your operating system (OS). This procedure provides
instructions for installing driver software on a Windows OS.
NOTE
To install the driver from the Device Manager:
1. Click Start in the Start bar. Type Device in the search box.
2. Select Device Manager from the list above the search box. The Device Manager displays (see
4 Eaton Power Xpert® Gateway PXGX UPS Card Quick Start Instructions 164950240—Rev 04
To verify the DHCP-assigned IP address, go to the
To manually enter a fixed IP address, go to the
You can use either the Device Manager path or the Devices and Printers path to browse
for the driver software and install it. This procedure uses the Device Manager.
Obtain a DHCP-Assigned IP Address
Assign an IP Address Manually
Install the Driver Software section to confirm that you
section.
section.
Figure 5).