Obtain a DHCP-Assigned IP Address
•
•
NOTE
3.
Select Network from the Configuration menu. The Network page displays (see
Figure 9. DHCP Enabled and Name Service Settings
4.
Under IPv4, the Automatic Configuration: DHCP Enabled setting checkbox should be enabled by
default. Make sure the checkbox is checked (enabled) before continuing.
5.
Scroll down to Name Service and expand the selection to update the next two DHCP settings:
•
Check the checkbox (enable) for Use DHCP (when enabled) to get name services.
•
Check the checkbox (enable) for Use DHCP (when enabled) to get domain name.
8
Eaton Power Xpert® Gateway PXGX UPS Card Quick Start Instructions 164950240—Rev 04
For firmware versions older than 2.6.0.5 the default username and password is "admin".
The PXGS card Web page displays.
If the system is unresponsive and you cannot make any selections, the browser may be
running in compatibility mode. To disable compatibility mode, go to the
Disable Browser Compatibility Mode
section.
Figure
9).