Obtain A Dhcp-Assigned Ip Address; Assign An Ip Address Manually - Eaton Power Xpert Quick Start Instructions

Gateway (pxgx) ups card

Hide thumbs Also See for Power Xpert:

Instruction booklet (16 pages)

Table Of Contents

Table of Contents

Figure 8. Update Driver Software Window – Update Successful

Click Close.

10. Either obtain the DHCP-assigned IP address or manually enter a fixed IP address:

•

To obtain the IP address assigned through DHCP, continue to the

section.

•

To manually enter a static (fixed) IP address for the card's network connection, go to the

Assign an IP Address Manually

NOTE

O O b b t t a a i i n n a a D D H H C C P P - - A A s s s s i i g g n n e e d d I I P P A A d d d d r r e e s s s s

NOTE

To obtain the IP address through DHCP:

Ensure the PXGX UPS card is still connected to the computer over the USB cable. Also ensure that the

network cable is connected from the PXGX UPS card Ethernet port to the network connection.

If your Web browser already open to the default IP address, go to

following:

Open your Web browser.

Enter: https://169.254.0.101 for firmware 2.6.0.0 or later, http://192.168.200.101 for earlier

firmware versions.

Log on as administrator.

•

By default, the PXGX UPS card requests an IP address through DHCP when connected

to a network.

If connecting PredictPulse via an Eaton wireless modem, refer to the document

Connecting a NetComm Wireless NTC-140W Series Router to an Eaton Network Card

rather than this section.

For firmware 2.6.0.5 and higher the username is "admin" and the default password is the card's

MAC address (case sensitive with no colons).

For example: Card's MAC address: 00:E0:D8:FF:C0:C4

–

Administrator name: admin

–

Password: 00E0D8FFC0C4

Eaton Power Xpert® Gateway PXGX UPS Card Quick Start Instructions 164950240—Rev 04

section.