OLT 12x4 GardenSaver Shed Assembly Manual page 26

Remove Metal
Roof Hangers
Secure lower/front
Batten row, be careful
not to overtighten.
Center of Battens
44.
Using 5 - 2" Metal Screws and 1/4" Nut Driver, secure Metal Roof Panels
down to lower/rear Batten row. Tighten screws in middle Batten row which were
partially attached in Step 42. Do not overtighten!
Note: If Top Siding Pc. for
Angle Wall was
installed in Step 16 it can
be done now. Attach with
3 - 1 1/2" Finishing Nails
per piece.
Toll Free 1-888-658-1658
Insert Foam
Enclosures
not
www.outdoorlivingtoday.com
Page 26
43.
Before fully fastening Metal Roof
Panels down, remove the Metal Roof
Hangers and insert Foam Enclosures
between Metal Roof Panels and Battens at
the rear/bottom. Enclosures will prevent
moisture and unwanted bugs, etc from
entering your shed from here.
Foam Enclosures x 4 total
Tighten middle row, be
careful not to overtighten.
sales@outdoorlivingtoday.com
Parts
Hardware
2" Metal Roof Screws
x 5 total