OLT 12x4 GardenSaver Shed Assembly Manual page 10

10.
Position rear solid wall into place on plywood floor. Butt both vertical wall
studs of side and rear walls together and attach with 3 - 2 1/2" Screws.
Screw at the bottom, middle and top of stud to secure properly.
Note: Drill pilot holes in studs to prevent splitting.
11.
With the corner wall attachment complete, position a second rear wall panel in place so bottom
2x3 wall framing is sitting flush with outside floor joists. Wall siding should overhang floor by
approximately 3/4". When positioned correctly, attach both side wall panel studs together as per Step 10.
Toll Free 1-888-658-1658
Optional - Caulking
seams will help prevent
moisture from entering
at seam. Caulking not
included in kit.
Be sure that the rear
wall panels fit
between the side wall
panels (sandwiched).
www.outdoorlivingtoday.com
Page 10
Pilot Hole
first.
Hardware (Steps 10 - 12)
S1 - 2 1/2" Screws
x 12 total
sales@outdoorlivingtoday.com