OLT 12x4 GardenSaver Shed Assembly Manual page 19

26.
Carefully flip completed Rafter Section over so Front Soffit is facing the front and place on GardenSaver
walls. Note: Double check that your Rafter Section is positioned correctly by ensuring the ends of the
Rafters are sloped vertically as shown above.
Back cut rafter to
the back.
27.
Position completed Rafter Section on top of walls. Outside Rafters will sit on Extension Wall framing
and be positioned equally from side to side.
28.
When Rafter Section is positioned correctly, both Front and Rear Soffits will sit approximately 1/8"
away from wall siding. This can vary slightly.
1-888-658-1658
Rafter sits
on framing.
www.outdoorlivingtoday.com
Page 19
Rafter ends vertical.
Side View
Check inside-to-inside
measurements of wall
studs. This should be
consistent along the
length of the shed,
approximately 40 1/2".
sales@outdoorlivingtoday.com