OLT 12x4 GardenSaver Shed Assembly Manual page 25

Bead of Caulking
Loosely attach middle row before
removing Metal Roof Hangers.
Screw into center of Battens.
42.
Using 5 - 2" Metal Screws and 1/4" Nut Driver (included), partially secure
Metal Roof Panels down to the middle Batten row. Only fasten screws half way
so the Metal Roof Hangers can be removed. Metal screw is self-tapping, screw
into the center of Battens.
Ten more 2" Metal Screws will be required to further secure Metal Roof Panels
and to complete Metal Drip Caps in later steps.
Toll Free 1-888-658-1658
Note: Metal Roof Hangers will
need to be removed in Step 43.
Screw into Peak
not valley.
www.outdoorlivingtoday.com
Page 25
41.
Once Metal Roof is spaced correctly
from side-to-side and top-to-bottom, lift
panels up and run a bead of caulking
down the overlapping seams of each
panel to seal the joints. You will likely need
assistance from a helper in this step.
2" Metal Roof Screws
sales@outdoorlivingtoday.com
Hardware
x 5 total