Error List - Canon MARKLL WUX10 Command List

7. Error List

Item Code TYPE Error character strings
1 0001 e BAD_SEQUENCE
INVALID_COMMAND
2 0002 e
INVALID_FORMAT
3 0004 e
NOT_POWER_SUPPLIED
4 0005 e
BUSY (POWER)
5 - i
INVALID_PARAMETER
6 000A e
JOB_TIMEOUT
7 000B e
BUSY (FOCUS)
i
BUSY (ZOOM)
i
BUSY (LOGO_CAPTURE)
i
9 -
BUSY (IMAGE)
i
BUSY (NOW_SETTING)
i
BUSY
i
NOW_BLANK
1006 e
NOW_FREEZE
1009 e
10
NOW_D.ZOOM
100A e
NOW_SPECIAL_MENU
100B e
Revision History / Date
Projector WUX10 MarkII User Commands
Error
Communication sequence error
Invalid (undefined) command.
Invalid command format.
The projector's power is off.
The projector is switching power
modes.
The parameter (type) is invalid
(undefined). Includes cases when
the number of parameters is
incorrect.
Internal processing in the projector
has timed out.
The focus lens is being driven.
The zoom lens is being driven.
User image registration is in
progress.
Image mode switching is in
progress.
Signal setting (detection) in
progress.
Internal processing in the projector
is in progress.
Cannot execute command since
blanking operation is in progress.
Cannot execute command since
freeze operation is in progress.
Cannot execute command since
D. zooming is in progress.
Cannot execute command in
current menu mode.
Changes
- 81 -
Remedy
Wait until a response is received
before sending the next command.
Send a valid command.
Send the command in the valid
format.
Turn on the power using the
POWER ON command.
Wait until the power mode is ON,
OFF or PMM.
Use the correct parameters.
Resend the command.
Wait until the projector has finished
driving the focus lens.
Wait until the projector has finished
driving the zoom lens.
Wait until user image registration is
complete.
Wait until the projector has switched
the image mode.
Wait until the processing is
completed.
Wait until the current processing is
complete.
Resend the command after
canceling the blanking operation.
Resend the command after
canceling the freeze operation.
Resend the command after
canceling D. zooming.
Resend the command after exiting
the current menu mode.
Revised by
Approved by