Sel - Canon MARKLL WUX10 Command List

SEL

Input signal selection
Format
SEL=<Input signal selection parameter:ID>
GET□SEL
<Input signal selection parameter:ID>
AUTO
Environment
Power
OFF ON
X O
Response
"i:OK" is returned if the parameter was set properly.
For '
GET SEL
'g:SEL=<Detected input signal:ID>'
(Refer to "Description".)
For details on other responses, refer to the "Error List".
Description
(1) This selects the input signal.
(2) This command functions in the same way as when "Display setting" - "Input signal selection" -
"AUTO" are selected on the menu.
(3) If the input is neither "COMP", "S-VIDEO" nor "VIDEO", 'e:200X INVALID_SOURCE(***)' is
returned as an error response.
(4) If signals are not input, 'e:2010 NO_SIGNAL' is returned.
(5) The current input signal can be acquired using the applicable GET command. ("
List of signals which can be detected (1)
Parameter
PAL
SECAM
NTSC
1080p
1080i
1035i
List of signals which can be detected (2)
Parameter
720p
576p
480p
576i
480i
UNKNOWN No-color, 1080p, and other signals
Revision History / Date
/ ?△SEL
Auto
PM D-RGB A-RGB1 A-RGB2 COMP
X X X X
' or ' ', current input signal is returned as
?SEL
Remarks
Includes PAL-M and PAL-N
Includes NTSC4.43
Includes 540p (1080i non-interlaced signal)
Remarks
Includes 288p (PAL non-interlaced signal)
Includes 240p (NTSC non-interlaced signal)
Changes
Projector WUX10 MarkII User Commands
Input
VIDEO HDMI
O O X
- 69 -
None
X
GET SEL
Revised by
Approved by
")