Image - Canon MARKLL WUX10 Command List

IMAGE

Image mode setting
Format
IMAGE=<Image mode setting parameter:ID>
GET□IMAGE
<Image mode setting parameter:ID>
STANDARD
PRESENTATION
SRGB
MOVIE
PHOTO
DCM_SIM
* "e:000A INVALID_PARAMETER" is returned if the model is not DICOM compatible
Environment
Power
OFF ON
X O
Response
"i:OK" is returned if the parameter was set properly.
For '
GET IMAGE
'g:IMAGE=<Image mode setting parameter:ID>'
For details on other responses, refer to the "Error List".
Description
(1) This sets the image quality.
(2) This command functions in the same way as when "Image adjustment" - "Image mode setting"
are selected on the menu.
(3) The final settings for the image mode are retained even when the power is turned off.
(4) Changing the setting may modify the following setting values.
Brightness
Contrast
Sharpness
Gamma adjustment
Dynamic gamma
Progressive
Saturation/Hue
Memory color adjustment
RGB gain/offset adjustment
Lamp mode
6-axis adjustment
6-axis color correction
(5) The current image quality can be acquired using the applicable GET command. ("
Revision History / Date
/ ?△IMAGE
Standard
Presentation
sRGB
Movie
Environmental light compatible sRGB
DICOM monochrome *
PM D-RGB A-RGB1 A-RGB2 COMP
X
' or ' ', current image mode is returned as
?IMAGE
Setting
Changes
Projector WUX10 MarkII User Commands
Input
VIDEO HDMI
-
Commands related to the settings
BRI
CONT
SHARP
GAMMA
DGAMMA
PROG
SAT/ HUE
MEMCADJ
RGBGAIN/RGBOFFSET
LAMP
6AXADJ
6AXR～Y
- 40 -
None
GET IMAGE
Revised by
Approved by
")