Rcch - Canon MARKLL WUX10 Command List

RCCH

Remote control channel setting
Format
RCCH=<Remote control setting parameters:ID>
GET□RCCH
<Remote control setting parameters:ID>
1
2
Environment
Power
OFF ON
X O
Response
"i:OK" is returned if the parameter was set properly.
For '
GET RCCH
'g:RCCH=<Remote control setting parameters:ID>'
For details on other responses, refer to the "Error List".
Description
(1) This command is used to set the channel of the remote control used at the projector end to 1 or
2.
(2) This command functions in the same way as when "System setting" - "Other settings" -
"Remote control setting" are selected on the menu.
(3) The current remote control setting can be acquired using the applicable GET command. ("
")
RCCH
Example
Setting
> RCCH=1
< i:OK
Reference
> GET RCCH or ?RCCH
< g:RCCH=2
* Commands are indicated by ">", and responses are indicated by "<".
Revision History / Date
/ ?△RCCH
Remote control channel 1
Remote control channel 2
PM D-RGB A-RGB1 A-RGB2 COMP
X
' or ' ', current remote control channel setting is returned as
?RCCH
This sets the remote control channel to ch1.
This retrieves the remote control setting state.
Changes
Projector WUX10 MarkII User Commands
Input
VIDEO HDMI
-
- 61 -
None
Revised by
Approved by
GET