Treadbelt Tensioning - Landice 90 Series Owner's Manual

Installation
4. Lock each leveling foot into place by threading the 19mm
nut until it touches the bottom of the frame. Turn the 19mm
nut counterclockwise and 14mm nut clockwise using an
open end wrench to lock each foot into place.

2.3.6. Treadbelt Tensioning

1. Before checking treadbelt tension, make sure treadmill is
level. (See "Leveling Feet" on page 37.) At proper tension
you should be able to place your hand between the belt and
deck and reach the center of the treadmill (Figure 2-21).
•
•
Figure 2-21. Treadbelt Tension Check
38
If you cannot reach the center, the belt is too tight.
If your hand reaches past the center, the belt is too
loose.