Battery Status & Charging - ADJ ELEMENT ST HEX User Instructions

Element ST Hex
4. Battery Storage
When storing the battery, it should be stored at room temperature, with a charge of at least 50%. We
recommend that during long periods of storage that the battery be charged every 6 months. Doing
this will prolong the life of the battery and will also make sure that the battery charge does not fall
below the 30% mark.
5. Other Chemical Reaction
Because batteries utilize a chemical reaction, battery performance will deteriorate over time even if
stored for a long period of time without being used. In addition, if the various usage conditions such
as charge, discharge, ambient temperature, etc. are not maintained within the specified ranges, the
life expectancy of the battery maybe shortened or the device in which the battery is used may be
damaged by electrolyte gel leakage. If the batteries cannot maintain a charge for long periods of
time, even when they are charged correctly, this may indicate it is time to change the battery.
6. Battery Disposal
Please dispose of battery according to local regulations.
Element ST Hex
Battery Status:
This function is used to check the battery life status.
1. Plug the fixture in and press the BATTERY icon.
2. Press the UP or DOWN buttons to highlight CURRENT LIFE and press ENTER. The number that is
displayed is the remaining battery life.
Never let the battery fully die, this severly shortens the life of the battery.
Battery Charging:
This function is used to check the battery charging status.
1. Plug the fixture in and press the BATTERY icon.
2. Press the UP or DOWN buttons to highlight CHARGING TIME and press ENTER. The number that
is displayed is the remaining battery life.
To recharge the battery, plug the supplied power adapter into the input located on the bottom of the
unit and plug the other end into a matching power source. TO CHARGE THE BATTERY, THE POWER
SWITCH MUST BE IN THE "ON" POSITION. It takes about 5 hours to reach full charge.
NOTE: CHARGING TIME will display "------------" when:
- The power adapter is NOT connected.
- The POWER SWITCH is "ON" but the LOAD setting is set to "OFF".
- The power adapter is connected but the POWER SWITCH is "OFF".
Note: When unplugging the unit from charging and then applying power via battery, there will
be a minimal charge drop.
For faster charging, turn the POWER SWITCH "ON" and the LOAD setting to "OFF".
ADJ Products, LLC - www.adj.com - Element ST Hex User Manual Page 8
Battery Precautions
Battery Status & Charging