In-Case Charging - ADJ MIRAGE Q6 PAK BLACK User Manual

I N - C A S E C H A R G I N G
1. Lock the wheel casters by pressing down on the levers located near each caster.
2. Connect power cables to both the power in and power out ports, if desired. Please refer to the
Daisy Chain Power Linkage section of this manual for details.
3. Remove the rubber cap from the charging port for each unit. NOTE: It is recommended to fold
the rubber cap back and over the closest CORNER of the device before placing it into its
charging slot in the flight case. Refer to the top left image below.
• When placing the fixture in the case slot, the rubber cap should tuck neatly into the gap in the
corner of the slot (see bottom image).
• Do NOT fold the rubber caps back over the side edges of the unit, as the device will not fit in the
flight case compartment this way. Refer to the top right image below.
• Do NOT allow the rubber cap to get caught underneath the device, as this will interfere with the
charging of the device.
CORRECT
4. Place an ADJ Mirage Q IP Black device in any of the device slots in the flight case. Up to 6 devices
can be accommodated. The charge indicator located beside the power ports will illuminate to indi-
cate that your device is charging. It is strongly recommended to leave the case lid open during
charging.
TUCK CAP INTO
CORNER OF
CHARGING SLOT
19
INCORRECT