In-Case Charging - ADJ ELEMENT H6 FC User Manual

IN-CASE CHARGING

*Element H6 Not Included
1. Lock the wheel casters by pressing down on the levers located near each caster.
2. Disengage the two latches and raise the case lid.
3. Once the lid has been opened, lift the upper end of the support bar and attach it to the recessed
catch on the underside of the lid, along the right-hand side. Make sure that the catch is fully seated in
the support bar's groove before reaching into the flight case. Please refer to safety section for de-
tailed details (page 8).
4. Connect the included power cable into the Power-In port. If power linking cases together, please
refer to the Daisy Chain Power Linkage section of this manual for details (page 11).
5. Place an ADJ Element H6 in any one of the charging compartments in the flight case. Up to (6)
units can be charged at one time. The charging indicator located beside the power ports will illumi-
nate to indicate that your device is charging. It is strongly recommended to leave the case lid
open during the charging process.
10