Commissioning, inspection, maintenance
Commissioning the heating system
Selecting the solar diverter valve
Available if the following settings were previously
selected:
■
"Solar on boiler"
and
■
"DHW"
and
Buffer temperature sensor "3", "4" or "5".
■
Setting the solar DHW maximum temperature
Available if previously:
■
"Solar on boiler"
and
"DHW" were selected
■
or
■
Buffer type "1" was selected.
Setting the maximum solar collector temperature
Available if "Solar on boiler" was selected.
Press the following buttons:
1.
/
for the required max. collector temperature.
|
~
Selecting the set DHW temperature for reheating suppression
Available if previously:
■
"Solar on boiler"
and
"DHW"
■
or
■
Buffer type "1" was selected.
Setting the nominal flow rate
Available if "Solar on boiler" was previously selected.
Press the following buttons:
1.
/
for the nominal flow rate in the collector cir-
|
~
cuit.
Selecting the minimum system temperature
Available if "No" for cascade and one control circuit
(e.g. heating circuit, DHW heating, etc.) was previously
selected.
58
(cont.)
Press the following buttons:
1.
/
"Not connected" for "Not installed"
|
~
or
"On the boiler" for "Connected at internal
PCB".
2.
to confirm.
d
Press the following buttons:
1.
/
for the required max. DHW temperature.
|
~
2.
to confirm.
d
2.
to confirm.
d
Press the following buttons:
1.
/
for the set temperature for active reheating
|
~
suppression.
2.
d
to confirm.
2.
to confirm.
d
Press the following buttons:
1.
/
to select "Yes" or "No" for the minimum sys-
|
~
tem temperature.
2.
to confirm.
d