Viessmann Vitoligno 300-C Installation And Service Instructions Manual page 26

Installation sequence
Pellet supply via flexible screw conveyor
Connecting the drive unit
2.
Fig. 18
1. Screw plug attached to the boiler into the pel-
sVK
let sensor.
2. Plug in the drive motor plug at the motor and feed
the electrical cable through the opening in the side
panel. Route the electrical cable in the cable guide
to the control unit and secure with cable ties, see
page 30.
The slot for the connecting cable can vary depend-
ing on the configuration of the screw conveyor and
may need to be changed.
26
(cont.)
1.
Note
Replacing the connecting cable plug, if necessary:
■ Slot sYK
charge from pellet store:
The drive motor cable is delivered with plug
■ Slot
sYH
port between room discharge and feed screw con-
veyor:
Plug
sYK
with plug
with flexible screw conveyor as dis-
with flexible screw conveyor for trans-
of the connecting cable must be replaced
. ( is located on ZPK PCB).
sYH sYH
.
sYK