Programming And Managing Personal Codes - PREVOST X3-45 VIP 2017 Owner's Manual

NOTE
After repeated attempts to enter codes (20
button presses without enabling), the keypad
will enter in an inactive mode that disables
buttons for 60 seconds. The lock indicator will
flash amber and red during this state.
If a partial validation code is entered or no
action button is pressed within 5 seconds, the
keypad will revert back to disabled condition
and the access code will have to be entered
again.
PROGRAMMING AND MANAGING
PERSONAL CODES
It is possible to program up to 40 four (4) digits
personal access codes to unlock the entrance
door and compartments. These codes do not
replace the default code that is factory supplied
with the vehicle.
When programming codes, do not choose
codes that present the numbers in sequential
order, studies show that people who idly press
the buttons usually press a sequential pattern.
Also, do not select a code that uses the same
button four times, thieves can easily figure out
these types of codes.
To add a new personal code:
Choose and memorize a four (4) digits
o
personal code.
Press and hold the 5/6 key for five seconds
o
(keypad will start to beep and flash).
Enter the vehicle factory six (6) digits
o
authority code.
Press the 1/2 key (a short beep will be
o
heard, validating the action).
NOTE
-If the 40 codes memory is already full, a long
beep will be heard.
- At any time, press the 9/0 key to exit
programming mode.
Enter the chosen personal code (three
o
confirmation beeps will be heard).
Re-enter the code to confirm the entry (four
o
confirmation beeps will be heard).
Press the 1/2 key and repeat the last two steps
to enter additional codes.
Other Features
To delete a personal code:
Press and hold the 5/6 key for five seconds
o
(keypad will start to beep and flash).
Enter the vehicle factory six (6) digits
o
authority code.
Press the 3/4 key (a short beep will be
o
heard, validating the action).
NOTE
-If the 40 codes memory is already empty, a
long beep will be heard.
- At any time, press the 9/0 key to exit
programming mode.
Enter the code to be deleted (three
o
confirmation beeps will be heard).
Re-enter the code to confirm the deletion
o
(four confirmation beeps will be heard).
Repeat the process to delete additional codes.
To delete all stored personal codes:
Press and hold the 5/6 key for five seconds
o
(keypad will start to beep and flash).
Enter the vehicle six (6) digits authority code.
o
Press the 3/4 key (a short beep will be
o
heard, validating the action).
NOTE
-If the 40 codes memory is already
empty, a long beep will be heard.
-At any time, press the 9/0 key to exit the
programming mode.
Press the 1/2
o
simultaneously (a confirmation double beeps
will be heard).
Re-enter the authority code to confirm the
o
deletion (four confirmation beeps will be
heard, a two second beep indicates an
incorrect authority code).
5-27
and the 9/0 keys