Daytime Running Lights; Fog Lights; Cornering And Docking Lights - PREVOST X3-45 VIP 2017 Owner's Manual

 Lift the vehicle rear end. Slide axle forks and
supports onto tow bar and install onto engine
cradle.
CAUTION
To prevent damage to the vehicle structure, it
is not recommended to tow the vehicle from
the rear. In case of damage to the drive train
components, use a low bed semi-trailer to
support the rear end.
DANGER
Do not carry passengers while the vehicle is
being towed.
CAUTION
Make sure axle shafts or driveshaft are
installed correctly after towing. Tighten axle
shaft and driveshaft nuts to the correct torque
settings. Do not invert shafts.
Safety Features and Equipment

DAYTIME RUNNING LIGHTS

The inner lamps only also called high beams
illuminate automatically when the engine is
started and the parking brake is released to
serve as daytime running lights. The daytime
running lights provide added safety by making
the traveling vehicle more visible to other drivers
during the day.
The daytime running lights system turns the
headlights on when:

Engine is running;

Parking brake is released;

The exterior lighting switch is set to the OFF
position or pressed to the first position.
WARNING
Do not drive with only the daytime running
lights at night because the tail and marker
lights are not turned on in that situation and
the high beams can blind other drivers. For
night driving, turn ON the headlights by
depressing the exterior lighting rocker switch
to the second position.

FOG LIGHTS

Optional halogen fog lights are available. They
provide better visibility in fog and precipitation.
They improve visibility immediately in front of the
vehicle. They also provide added safety.
NOTE
Some states or provinces may restrict the use
of fog lights. Verify local state or provincial
regulations before using.

CORNERING AND DOCKING LIGHTS

The vehicle may be equipped with up to four
halogen cornering lights. Two lights are installed
at the front of the vehicle, on each side as
standard equipment. Two optional lights may be
installed on each side at the rear of the vehicle.
When activated, the front lights illuminate at the
same time as the turn signal flashers to increase
lateral visibility while turning. The rear lights
illuminate when the reverse (R) range is
selected to increase visibility while backing-up
the vehicle. All four lights will illuminate when the
docking position is selected using the rocker
7-13