Table of Contents
Advertisement
Initiating a Stationary (Parked) Regeneration
NOTE
At starting of the engine, if a stationary
regeneration is required, the engine coolant
temperature must reach 140°F (60°C) before
any stationary regeneration may be initiated
and completed. Permit the engine to idle for a
short while or drive the vehicle until engine
temperature increases sufficiently.
WARNING
Do not initiate a stationary regeneration in a
closed
area
like
regenerations must be undertaken outdoors
only.
WARNING
During
stationary
temperature may reach up to 1200°F (650°C)
at
the
particulate
stationary regeneration, make sure that the
DPF outlet diffuser is clear of objects and that
no one is working near the DPF outlet diffuser.
WARNING
Hot surfaces. Keep yourself clear of all hot
Aftertreatment Device components, particularly
during
and
after
regeneration. Hot surfaces can cause serious
burns.
NOTE
STATIONARY REGENERATION
This process requires the vehicle to be parked
while the driver or a maintenance technician
initiates the regeneration process.
The
DPF
REGENERATION
illuminates to notify the driver of the need and
urgency of a manual stationary regeneration.
DPF REGENERATION telltale light
If stationary regeneration is not performed, this
telltale light will blink, indicating that a stationary
regeneration
is
required
stationary regeneration is still not performed,
a
garage.
Stationary
regeneration,
exhaust
filter.
Before
initiating
active
or
stationary
telltale
light
immediately.
"engine power derate and shutdown" sequence
may occur as per level 1 to level 4 sequence.
To initiate a stationary regeneration:
• Park the vehicle in a clear area, vehicle
speed must be 0 mph (0 km/h);
• Engine must be on normal idle and fully
warmed up (coolant temperature above
140°F/60°C);
• Apply
parking
transmission to neutral (N).
• Press the DID ENTER button and then get to
the DID Aftertreatment menu.
menu Request Parked REGEN and press
ENTER
regeneration.
The regeneration will begin. Turn off the air
conditioning to reduce engine load. The engine
idling speed will increase to 1600 rpm. Once the
regeneration is completed, the engine speed will
return to normal idle.
Voluntary
Regeneration
It
is
possible
regeneration at all time. To do so, set the ignition
key to the OFF position or get to the DID's
Aftertreatment menu, select Cancel REGEN and
press ENTER button to confirm. You can stop
regeneration simply by releasing the parking
brake. Use this procedure in order to move the
vehicle in a safe area only.
If regeneration is interrupted, it is very important to
reinitiate the regeneration as soon as possible.
CAUTION
If an active regeneration is stopped repeatedly,
the vehicle may need to be taken to a service
facility. The service facility will use a service
tool to manually initiate the regeneration.
Moreover,
regeneration should not be considered as a
normal practice. Some components of the
aftertreatment system might be damaged in
the long term.
If
Other Features
brakes
and
button
to
confirm
Interruption
of
a
to
interrupt
a
the
interruption
5-5
set
the
Select sub-
and
initiate
Stationary
stationary
of
active
Advertisement
Chapters
Table of Contents
Troubleshooting
