Power Steering Fluid Level; Drive Axle Wheel Bearing Oil Level; Front And Tag Axle Wheel Hubs; Coolant Fluid Level - PREVOST X3-45 VIP 2017 Owner's Manual


Hot Check
Make sure the transmission fluid temperature is
o
between 180 F and 220
before performing the hot check. Run the engine
between 1,000 and 1,200 RPM for approximately
one minute to purge air from the system. With
the engine idling and the parking brake applied,
shift transmission from forward (D) to reverse
(R) and back into neutral (N) to fill clutch cavities
with oil. Remove and clean dipstick, then check
oil level. If the oil level is on or under the lower
HOT RUN line, add just enough oil to bring up
the level to the middle of the HOT RUN band.
TRANSMISSION FLUID LEVEL DIPSTICK (TYPICAL)
Replace dipstick and tighten the filler tube cap
until the rubber seal is correctly seated.
CAUTION
Do not overfill transmission fluid reservoir.
Severe damage may result.

POWER STEERING FLUID LEVEL

The vehicle is equipped with a power steering
system. The hydraulic fluid tank is located in the
engine compartment behind the engine air intake
pipe and above the alternators..
o o o
F (82 C and 104 C)
07049
Care and Maintenance
ENGINE COMPARTMENT
Check fluid level as follows:
1. Stop engine, open engine compartment
doors and place rear start switch to OFF
position;
2. Unscrew and remove the dipstick located on
top of the fluid tank and wipe with a clean
rag;
3. Replace dipstick in tank, then remove to
check fluid level;
4. Add hydraulic fluid until it reaches the FULL
mark on the dipstick;
5. Replace and tighten dipstick;
6. Place engine rear start switch to NORMAL
position. Close engine compartment doors.

DRIVE AXLE WHEEL BEARING OIL LEVEL

Drive axle wheel bearings are lubricated by the
differential oil. Maintain differential oil at correct
level to ensure adequate lubrication of drive axle
wheel bearings at all times.

FRONT AND TAG AXLE WHEEL HUBS

The unitized hub bearings used on the NDS range
of axles, are non-serviceable items. Bearings are
pre-adjusted, lubricated and have seals fitted as
part of the manufacturing process. The bearings
are greased for life and there is no need or facility
for re-lubrication.

COOLANT FLUID LEVEL

Check the coolant level when the engine is cold
(room or ambient temperature).

If the coolant level has reached the bottom
of the sight glass, add coolant up to the
middle of the sight glass.
Fill the tank as required with the same 50/50
water-antifreeze mixture already in the cooling
system. Do not mix two different types of
coolant. Refer to the Maintenance Manual for
proper coolant type specifications or see the
label affixed near the coolant surge tank on the
vehicle.
8-7
14059