PREVOST X3-45 VIP 2017 Owner's Manual page 170

8-18 Care and Maintenance
STEP 3: FRONT RIGHT SIDE OF THE
VEHICLE

Check condition of wheel rim. Especially
look for cracks, missing nuts, bent or
broken studs.

Check condition of tire: properly inflated,
no serious cuts, bulges, tread wear or
any signs of misalignment; valve stem
not touching wheel or rim; valve cap in
place.
STEP 4: REAR RIGHT SIDE OF THE VEHICLE

Check condition of wheels and rims.
Especially look for cracks, missing nuts,
bent or broken studs.

Check that
compartment doors are properly closed.

Check condition
inflated, no serious cuts, bulges, tread
wear or any signs of misalignment; valve
stems not touching wheels or rims; valve
caps in place and no objects stuck
between the wheels.
STEP 5: ENGINE COMPARTMENT RIGHT
SIDE AREA

Check engine and surrounding areas for
coolant, oil and fuel leaks.

Check fuel/filter water separator and
drain if necessary. Check for leaks.

Check wiring harness for signs of
damage.
STEP 6: ENGINE COMPARTMENT

Check engine and surrounding areas for
coolant, oil and fuel leaks.

Check wiring harness for signs of
damage.

Check condition of drive belts.

Check engine crankcase oil level, add if
necessary.

Check Allison transmission fluid level
(can also be checked from push-button
shift selector), add if necessary.
baggage and service
of tires: properly

Check power steering reservoir fluid
level, add if necessary.

Check coolant surge tank fluid level, add
if necessary.

Check air cleaner restriction indicator,
replace air cleaner when red signal locks
in full view.

Check stop light, tail light, directional
signal light and back-up light assembly;
operating, clean and proper color. Refer
to "Exterior Lighting Verification" in Care
and Maintenance chapter.
STEP 7: REAR LEFT SIDE OF THE VEHICLE

Check condition of wheels and rims.
Especially look for cracks, missing nuts,
bent or broken studs.

Check that
compartment doors are properly closed.

Check condition
inflated, no serious cuts, bulges, tread
wear or any signs of misalignment; valve
stems not touching wheels or rims; valve
caps in place and no objects stuck
between the wheels.
INSIDE THE VEHICLE

Check for proper operation of the
entrance door.

Check steps; clean them if there is any
substance that makes them slippery,
which makes
hazardous.

Check that emergency exit windows can
be opened then close all windows
securely.

Verify proper operation of windshield
wiper/ washer.

Adjust and clean mirrors for adequate
rear view vision.

Start engine and check for proper
operation of all gauges and indicator
lights.

Check for proper operation of electric
and air horns and back-up alarm.

Perform a brake test. Check both
primary and secondary pressure
gauges.
baggage and service
of tires: properly
vehicle entry/exit