Engine Protection System; Automatic Engine Shutdown; Idle Shutdown Timer - PREVOST X3-45 VIP 2017 Owner's Manual

BOOSTER BLOCK LOCATION
6. Let the engine run for a few minutes, then
start the vehicle with the run-down battery;
7. Disconnect the jumper cables in reverse
order given in steps 2 through 5;
8. Install protective cap on the booster block
terminal.
NOTE
Jumper cables must be rated at 500 cranking
amperes. If jumper cable length is 20 feet (6
m) or less, use 2/0 (AWG) gauge wires. If
cable length is between 20 to 30 feet (6 to 9
m), use 3/0 (AWG) gauge wires.

ENGINE PROTECTION SYSTEM

The engine protection will automatically derate
or stop the engine when certain engine
conditions reach a critical stage.
In the event of a serious fault, the red STOP
telltale light comes on and an audible alarm will
sound if the engine is running.
An illuminated STOP telltale light indicates a
serious problem has been detected, and the
driver must respond immediately to the problem.
The vehicle must be safely pulled off the road
and stopped. In some instances, the engine
must be switched off immediately.

AUTOMATIC ENGINE SHUTDOWN

Prior to an actual automatic shutdown, the
engine will automatically derate, go to idle, and
then stop as the vehicle speed gets below 2
mph (3 km/h).
Starting and Stopping Procedures
The engine
automatically derate and stop the engine when
one or more of the conditions listed below
reaches a critical point:
•
High engine coolant temperature
•
High engine oil temperature
•
Low engine oil pressure
•
High crankcase pressure (rate of change)
After the automatic engine shutdown sequence,
the engine may be restarted. To do so, turn the
ignition switch to the OFF position during 7
seconds and then turn it back to ON. However, it
will only operate for 30 seconds unless the
06623
problem is resolved.
Use this function sparingly and in order to move
the vehicle to a safe parking place only.
Excessive use may result in severe engine
damage.
Failure to take necessary action when the
STOP telltale light is on can ultimately result in
automatic engine derate and shutdown.

IDLE SHUTDOWN TIMER

The idle
programmed to shut down the engine after a
specific engine idling time. The idling time
cannot be changed by the driver but can be
changed with the use of a laptop computer and
Premium Tech Tool. In this case, the engine
idling time can be set from 30 seconds up to 1
hour.
The engine will shut down at the set time under
the following conditions:
•
Vehicle speed is 0;
•
Engine is running at normal idle speed;
•
Engine coolant temperature above 120°F
(49°C);
•
Temperature inside vehicle is between 59°F
(15°C) and 81°F (27°C);
•
Parking brake applied;
•
Transmission into neutral (N);
•
Wheelchair lift system not in use;
shutdown
WARNING
shutdown timer
6-5
protection will
(optional) is