Wheels And Tires; Recommended Tire Inflation Pressure At Maximum Cold Load; Belts - PREVOST X3-45 VIP 2017 Owner's Manual

9-6 Technical Information
standards based upon the use of test fuels with
specifications established by these regulatory
agencies.
Alternative fuels, including biodiesel, that are not
substantially similar to the required test fuels
may adversely affect
compliance. As a result, Volvo does not warrant
the engine will conform to applicable Federal or
California emissions limits when operated on
biodiesel or other alternative fuels that are not
substantially similar to specified test fuels used
for certification.
Additional maintenance is required and is
covered in the maintenance manual "Fuel
system" section.

WHEELS AND TIRES

Accuride steel wheels ......................... 9" X 22½"
Alcoa aluminum forged wheels ........... 9" X 22½"
Except inner drive axle (steel) .......... 8¼" X 22½"
Alcoa aluminum forged wheels
(for super single tire) ......................... 14" X 22½"
Tires ...................... 315/80 R22.5 load range "L"
Tires ...................... 365/70 R22.5 load range "L"
Tires (super single) 455/55 R22.5 load range "L"
RECOMMENDED TIRE INFLATION
PRESSURE AT MAXIMUM COLD LOAD
The recommended tire inflation pressures are
given in the applicable documents supplied with
the vehicle. In addition, minimum cold tire
inflation pressures are listed on the Department
of Transport (DOT) certification plate, affixed on
the left wall near the driver's seat.
NOTE
Bus Shells vehicles, before being converted,
are not at their maximum weight and tire
pressures are adjusted at lower level than the
maximum allowed appearing on the DOT
plate. Tires pressure must be re-adjusted
once converted.
WARNING
Special tire selection may lower maximum
allowable speed limit, even below posted
speed limit. For maximum safety, check with
tire manufacturer.
engine emissions
Vehicle equipped with TPMS: The TPMS target
pressures are factory set to equal the prevailing
tire pressure at delivery time. When tire
pressures are increased to account for higher
vehicle weight, the TPMS set point need to be
increased accordingly.
CAUTION
These tire pressures are established in
accordance with the maximum allowable load
on each axle.
recommended if the axle load is less than the
above specifications. Weigh vehicle fully
loaded and pressurize according to tire
manufacturer's recommendations.
For non standard tire and wheel specifications,
see Prevost tire
"Vehicle Final Record" .

BELTS

A: Alternator I: Idler
C: Crank WP: Water pump
Belt application
A/C system Bitzer 4NFCY
compressor
Alternator (twin Bosch, curb
side)
Alternator (emergency)
Alternator (single, driver
side)
Coolant pump
NOTE
Belts specifications may vary. For proper belt
selection, always consult your vehicle Vehicle
Final Record.
A lower pressure
pressure tabulation
T: Tensioner
AC: A/C compressor
Type
V Belt BX71
Multi-V-8 Rib
8PK1575
Multi-V-8 Rib
8PK1512
Multi-V-10 Rib
10PK1695
Multi-V-10 Rib
10PK1512
is
in
Qty
2
1
1
1
1