Water Tank - Silvercrest SLE 420 A1 Operating Instructions Manual

GB_RP89301_Luftbefeuchter.fm Seite 65 Freitag, 19. April 2013 9:13 09
AUTOMATIK
The setting for the target relative humidity
(RH) is fixed at 55%. The compressor dehu-
midifies until this value has been reached,
and will then switch off. When the relative
humidity rises again, the compressor switch-
es on again.
In this mode, the device operates in 3 differ-
ent stages:
- RH over 70%: the device dehumidifies
at its highest setting.
- RH between 55% and 70%: the device
dehumidifies at its normal setting.
- RH under 55%: no dehumidification,
only the fan is running.
NOTE: the relative humidity values of the
automatic system are not identical to the val-
ues HOCH/MITTEL/NIEDRIG on the dis-
play|13.
Select this mode for continuous dehumidifi-
cation to a pleasant relative humidity of 55%.
DAUERBETRIEB (CONTINUOUS)
In the DAUERBETRIEB mode, you can set the
relative humidity in 5% increments to be-
tween 30% and 80%. The device dehumidi-
fies at a low level until the set value has been
reached, and then deactivates itself. When
the relative humidity rises again, the device
switches on again.
30 - 80%: setting for the desired relative
-
humidity in the room.
CO: the device dehumidifies continu-
-
ously.
Select this mode for continuous dehumidifi-
cation, or for dehumidification to a value
that you have set.
WÄSCHETROCKNUNG (DRY CLOTHES)
You can use this mode in order to dry damp
clothes or shoes faster. The device dehumid-
ifies at its highest setting. Shift the flap
valve|1 of the air outlet in such a way that
the jet of air is directed towards the items of
clothing to be dried.
LUFTREINIGUNG (AIR CLEAN)
No dehumidification takes place with this
mode. The room air is drawn in through the
filter in front of the air inlet, and is cleaned
there.

7.4 Water tank

• The water tank 5 has a holding capaci-
ty of 5 litres.
• The water level can be checked using
the inspection window 7 in the front.
• The device can only be operated with
the water tank in place.
• When the water tank 5 is full, the WAS-
SERTANK VOLL LED 12 starts flashing.
The device switches off after a few sec-
onds. An alarm sounds for approx.
20|seconds. The WASSERTANK VOLL
LED|12 flashes until the tank has been
emptied.
1. Figure A: in order to empty the water
tank 5, pull it out slightly on the left and
right-hand sides, and then carry it by
the handle 3.
2. Pour the water out and place the tank
back in the device.
65
GB