Displays; Modes Of Operation - Silvercrest SLE 420 A1 Operating Instructions Manual

GB_RP89301_Luftbefeuchter.fm Seite 64 Freitag, 19. April 2013 9:13 09
Air outlet flap valve
Figure B: irrespective of which mode the
device is being operated in, open the top
flap valve 1. It clicks into place in four posi-
tions.
If the flap valve is not opened, the overheat-
ing protection will switch the device off after
a while for approx. 3 minutes.

7.2 Displays

The mode of operation LEDs 14 and the dis-
play 13 show the selected functions and the
humidity range.
Mode of operation LEDs
LED illuminated
The water tank is
WASSERTANK VOLL
full or has not been
(TANK FULL)
inserted.
TIMER AKTIV A switch-off time is
(TIMER) activated.
LUFTREINIGUNG
(AIR CLEAN)
WÄSCHETROCK-
NUNG
Selected mode
(DRY CLOTHES)
DAUERBETRIEB
(CONTINUOUS)
AUTOMATIK
BETRIEB The device is
(OPERATION) switched on.
64 GB
Display
Display
1 - 12
flash for 5 sec.
Meaning
30 - 80 or CO
flash for 5 sec.

7.3 Modes of operation

NOTE: the values selected for relative hu-
midity (RH%) are recognised with an up-
wards or downwards deviation of approx.
3%. This is necessary so that the device does
not constantly switch on and off.
• The device has 4 different modes avail-
able.
• By pressing the button 17 PRO-
GRAMM, you can switch between the
modes.
• The mode of operation LED 14 next to
the active mode illuminates.
Meaning
This display can be seen
continuously during oper-
HOCH
ation. It shows the humid-
MITTEL
NIEDRIG
ity range in the room:
NIEDRIG (LOW):
HOCH
under 65%
MITTEL
NIEDRIG
MITTEL (MID):
65% to 75%
HOCH
HOCH (HIGH):
MITTEL
NIEDRIG
over 75%
Timer for all modes:
These values (1 - 12 hours)
will flash for 5 seconds
when you use the arrow
keys to select a switch-off
time.
Set relative humidity in
continuous operation.
Values between 30 and
80 or CO will flash for
5|seconds when
selected.
CO: The device dehu-
midifies continuously.