Table of Contents
Advertisement
8
Fault Correction
20
8.1
Error Display
The appearance of an error will be shown on the display:
Figure 17
The error treatment is pending on the error type 8.2 on page 20.
The display offers the following possibilities to continue after an error occurred:
Repeat
Cancel
Feed
Ignore
Save log
Table 5
8.2
Error Messages and Fault Correction
Error message
Barcode error
Barcode too big
Buffer overflow
Device not conn.
Device not locked
File not found
Font not found
Initialization failed
Memory overflow
Name exists
No label found
No label size
No tube detected
Error display
The print job will be continued after clearing the error cause.
The print job will be cancelled.
The paper feed will be synchronized. Following the print job can be continued.
The error message will be ignored. The print job will be continued possibly with limited
performance.
The error does not allow print operation.
For detailed analysis several system files can be saved on an external memory.
Buttons in the error display
Cause
Invalid barcode content, e.g. alphanu-
meric characters in a numerical barcode
The barcode is too big for the allocated
area of the label
The input buffer memory is full and the
computer is still transmitting data.
Programming addresses a non-existent
device
The tube applicator is not in operating
position
Requested file is not on the card
Error with the selected download font
Hardware error tube applicator
Current print job contains too much infor-
mation, e.g. selected font, large graphics
Duplicate usage of field name in the direct
programming
There are labels missing on the label
material
The label format as set in the software
does not correspond with the real label
format
Device is loaded with continuous paper,
but the software is set on labels
The size of the label is not defined in the
programming.
No tube in the labelling area
Remedy
Correct the barcode content.
Reduce the size of the barcode or move it.
Use data transmission via protocol (preferably
RTS/CTS).
Either connect this device or correct the
programming.
Fold up the applicator.
Check the contents of the card.
Cancel current print job, change font.
Switch off and on the system.
If error recurs call service.
Cancel current print job.
Reduce amount of data to be printed.
Correct programming
Press Repeat repeatedly until device recognizes the
next label on the material.
Cancel current print job.
Change the label format set in the software.
Restart print job.
Cancel current print job.
Change the label format set in the software.
Restart the print job.
Check programming.
Insert tube.
20
Advertisement
Table of Contents
