Setting Of The Tape Feeding Amount - JUKI AMS-210ENHL2210/TF10S Instruction Manual

4-5. Setting of the tape feeding amount

The tape feeding amount differs with the tape material.
This means that it is necessary to set the tape feeding amount when the type of tape is changed to
a different one.
The tape feeding amount is set based on the length of tape that is actually fed.
① Displaying the tape feeding amount setting screen
When TEPE FEEDING AMOUNT SET button
pressed, the tape feeding amount setting screen is displayed.
② Feeding the tape and measuring the length
When TAPE FEED button
Measure the length of tape fed.
The correction value displayed when you press the
TAPE FEED button for the fi rst time on this screen is
the initial value of the feed length. It is not the correc-
tion value you have set previously.
③ Entering the measured tape length
Press button
The tape length is expressed in "mm".
After you have entered the tape length, press TAPE FEED
button to feed the tape.
Check to be sure that the length of the tape fed is 70.0 mm.
After you have checked the tape length, press ENTER button
to confi rm the setting.
– 61 –
is pressed, the tape is fed.
to enter the tape length measured.
is