Table of Contents
Advertisement
No.
Number of stitches
of thread clamp release is set.
Clamping timing
of thread clamp can be delayed.
Thread clamp control can be prohibited.
Normal
Feed motion timing is selected.
Set the timing in "–" direction when stitch is not
well-tightened.
Origin retrieval can be performed every time after end of
sewing
Without origin retrieval
Needle stop position is set.
UP position
Thread trimming can be prohibited.
Normal
Route of return to origin by return to origin button can be selected.
Linear return
Bobbin winding speed can be set.
Motion method of wiper can be selected.
Invalid
Thread tension output time when setting
thread tension can be set.
Bend position of thread clamp is selected.
1 : H type thin thread (#50 to #8)
2 : H type intermediate
3 : H type thick thread (#20 to #5)
Thread clamp and thread clamp position selection
Front position
Item
Prohibited
With origin retrieval
Upper dead point
Thread trimming
prohibited
Reverse return of
Origin retrieval →
pattern
Sewing start point
Magnet typewiper
Rear position
– 96 –
Setting range
Edit unit
1 to 7
1
– 10 to 0
1
---
---
– 8 to 16
1
---
---
---
---
---
---
---
---
800 to 2000
100 sti/min
---
---
0 to 20
1
---
---
---
---
Advertisement
Chapters
Table of Contents
