Table of Contents
Advertisement
2-3. Basic operation of IP-420
① Turning ON the POWER switch.
When the POWER switch is tuned ON fi rstly, the operation
check screen is displayed.
When the RESET button
unit carries out the origin retrieval.
1. Do not carry out tape supplying work immediately
after turning ON the POWER switch.
Since the tape feeder unit and the knife unit can
move, a personal injury may be caused.
2. On the operation check screen which appears after the
power is turned ON, press the RESET switch. Then, the
guide width motor carries out the origin retrieval.
After the completion of the origin retrieval, set the tape
on the feeder.
② Selecting the language for display
The language selection screen is displayed. Select the lan-
guage you use. (It can be changed by means of the MEMORY
switch U500.)
When ending the selection screen with CANCEL but-
ton
or ENTER button
language selection, the language selection screen is
displayed whenever the power is turned ON.
③ Scanning the bar-code corresponding to the sewing pat-
tern you want to sew
After the completion of the origin retrieval, the data entry
screen is displayed.
Scan the bar-code which corresponds to the sewing pattern
you want to sew with the bar-code reader.
(Refer to "II-3-2. Creating a bar-code" p.37 for detailed infor-
mation on the bar-code.)
When the barcode is red, the data corresponding to the
scanned bar-code appears on the screen.
When READY key
of the LCD changes over to green to indicate that sewing can
be started.
Place a garment body and press the START switch to start
sewing.
The bar-code can be read on both the setting screen and the
sewing screen.
– 30 –
is pressed, the tape feed
without performing the
is pressed, the background color
Advertisement
Chapters
Table of Contents
