How To Feed The Tape - JUKI AMS-210ENHL2210/TF10S Instruction Manual

5-3. How to feed the tape

❶
3) Feed the tape along the groove in tape travel guide ❹ .
At this time, check to be sure that the tape does not protrude as
❺
1. Do not carry out tape supplying work immediately after turning ON the POWER switch.
Since the tape feeder unit and the knife unit can move, a personal injury may be caused.
2. On the operation check screen which appears after the power is turned ON, press the
RESET switch. Then, the guide width motor carries out the origin retrieval.
After the completion of the origin retrieval, set the tape on the feeder.
3. In the case the tape is fed before the sewing machine completes the preparation for
sewing, the tape travel guide will move to cause the tape to be caught in the guide. If the
tape is fed before the sewing machine completes the preparation for sewing, draw out
the tape once from the tape travel guide. Then, wait until the sewing machine completes
the preparation for sewing and re-feed the tape.
1) Press ready key
the sewing machine in the ready state.
2) Place the tape on tape reel base ❶ . Pass
the tape through the hole in tape guide ❷ and
insert it into tape guide plate ❸ .
❷
❸
❹
4) Pull tape clamp ❺ upward to feed the tape until
it comes in contact with the top end of the knife.
– 23 –
to bring the main body of
.