Mechanical Specification; Module Dimension; Height On Top; Height On Bottom - Kontron nanoETXexpress-SP User Manual

3.6 Mechanical Specification

3.6.1 Module Dimension

» Listenpunkt55mm x 84mm (±0.2mm)

3.6.2 Height on Top

» Maximum approx. 3.5mm (withouth printed circuit board)
» Height is depending on (optional) CPU cooler / heat spreader

3.6.3 Height on Bottom

» Maximum appporx. 3.5mm (without printed circuit board)

3.6.4 Mechanical Drawing

All dimensions are shown in millimeters. Tolerances should be ± 0.25mm [±0.010"], unless otherwise noted. The
tolerances on the module connector locating peg holes (dimensions [16.50, 6.00]) should be ± 0.10mm [±0.004"].
The 220 pin module connector shall be mounted on the backside of the PCB and is seen "through" the board in this
view. The 4 mounting holes shown in the drawing should use 6mm diameter pads and should have 2.7mm plated
holes, for use with 2.5mm hardware. The pads should be tied to the PCB ground plane.
A complete Solid Works eDrawing package is available at Kontron's
17
nanoETXexpress-SP/Specification
EMD Customer Section