Exit From Config Mode; Use Usb To Configure The Its-Dx4020-G - Bosch Conettix ITS-DX4020-G Installation And Operation Manual

20 en | Configuration
Condition
1 No control panel authorization received.
2 Installer is authorized for Configuration mode,
or authorization is not required.
3 Received invalid SMS.
4 Received valid SMS authorizing configuration.
→
Key: = Scrolling LEDs, from left to right.
Table 4.6 Configuration Mode (J200 Jumper Installed) LED States
NOTICE!
If the LEDs indicate an invalid SMS, remove the configuration jumper and then repeat the
steps in Section 4.1.1 Enter CONFIG MODE, page 17.
If the LEDs continue to indicate an invalid SMS, the configuration SMS might be incorrect.
Ensure that your configuration SMS contains the correct information, or use the USB
connection to configure the ITS-DX4020-G.
4.1.4

Exit from CONFIG MODE

1.
2.
CELL IP LED State
Off
Flash
On
Table 4.7 CELL IP LED Status
4.2

Use USB to Configure the ITS-DX4020-G

You can use a USB connection from a laptop or desktop PC to the ITS-DX4020-G to configure
the ITS-DX4020-G on-site.
Before you can access the USB user interface, you must install the ITS-DX4020-G.inf file on
the target PC or laptop. The ITS-DX4020-G.inf file is available on the supplied CD-ROM. You
need to install this file only once on the target PC or laptop.
If the ITS-DX4040-G CD-ROM is not available:
1.
2.
3.
F01U163066 | 01 | 2010.05
Remove the jumper plug from the CONFIG MODE jumper pins.
The ITS-DX4020-G restarts.
Check the status of the CELL IP LED to see if the ITS-DX4020-G can communicate with
the central station receiver.
Refer to Table 4.7 for more information.
Status
The ITS-DX4020-G is not connected to the GPRS network.
The ITS-DX4020-G is connected to the GPRS network, but it is not
connected to the central station receiver.
The ITS-DX4020-G is connected to the central station receiver
through the GPRS network.
From your Internet browser, go to http://www.boschsecurity.com to open the Bosch
Web site.
Select the web site for your region and country.
In the Online Catalogs section on the left, click the Intrusion Alarm Systems link.
Installation and Operation Guide
LED State
STATUS CELL AUDIO SS1
IP
→ → →
→ → →
→ → →
→ → →
GPRS/GSM IP Communicator
SS2 SS3
GSM Signal Strength
GSM Signal Strength
Flash Flash Flash
→ → →
Bosch Security Systems, Inc.
BUS
Off
On
Flash
→