Bosch Conettix ITS-DX4020-G Installation And Operation Manual page 28

28 en | Configuration
Configuration ID
Enable Low Signal
Strength Reporting
(ID 59)
Table 4.9 UL 864 Required Configuration Settings
NOTICE!
Table 4.10 shows all parameters available through SMS or USB configuration.
Shaded rows are required parameters. Values in bold are default settings.
ID Parameter
1 Current Password
2 New Password
3 SIM PUK,PIN
4 SIM PIN
10 GPRS APN
11 GPRS username
12 GPRS password
13 Src port
14 Bus Address
15 AES Encryption
16 AES Encryption Key 32 characters max.
17 Communication
paths available
50 DTMF digit timeout
51 GPRS ACK timeout
52 GPRS Transmit
buffer lifetime
F01U163066 | 01 | 2010.05
Permitted in UL 864 (Y/N)
Y
Values
4 to 15 characters (4020G)
4 to 15 characters
Maximum 10 numeric digits each Sets a new PIN into the SIM and the ITS-DX4020-G.
4 numeric digits
1 to 63 characters (Airnet1)
1 to 63 characters
1 to 63 characters
1 to 65535 characters (7700)
– 88 (GV2 Series
or GV3 Series)
– 92 (GV3 Series)
– 134 (default)
– 250 (FPD-7024)
0 = Disabled
1 = Enabled
0-9, A-F, a-f allowed
– 1 = Both
– 2 = IP over GPRS
– 3 = PSTN (Contact ID) over
GSM
100 to 3000 ms (500 ms)
6 to 600 sec (70 sec)
6 to 120 sec (15 sec)
Installation and Operation Guide
Possible Settings Settings Permitted in UL 864
– 0 = Disabled 1 = Enabled
– 1 = Enabled
Description
Mandatory and case sensitive.
NOTICE!
Remember all passwords. Forgotten passwords
cannot be recovered, and the unit must be returned.
New password, as desired. Case sensitive.
Sets the PIN in the ITS-DX4020-G to match your SIM
card PIN.
Access point name.
User name for wireless service provider (not always
required).
Password for wireless service provider (not always
required).
Sets the source port for the ITS-DX4020-G.
Sets the control panel bus address for
communication with the control panel.
Security encryption on or off. The setting must
match the encryption settings in the receiver.
The AES Encryption Key must match the encryption
key in the receiver.
Select which communication path the
ITS-DX4020-G will use.
Acceptable time between dialed DTMF digits from
the control panel.
The GPRS session restarts if no response occurs by
the time the entered time expires.
Length of time the control panel messages remain
in the in the ITS-DX4020-G buffer before they are
discarded.
GPRS/GSM IP Communicator
Bosch Security Systems, Inc.