GPRS/GSM IP Communicator
6
Firmware Upgrade
To upgrade the firmware in the ITS-DX4020-G, you must download the latest firmware file
from the Bosch Web site to the target PC or laptop, and then use either Hyper Terminal or
Tera Term to install the firmware file on the ITS-DX4020-G.
6.1
Download the Latest Firmware
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Click Save to save the file to the target PC or laptop.
6.2
Install the Firmware
6.2.1
Install the Firmware using Hyper Terminal
NOTICE!
To install the firmware, the CONFIG MODE jumper pins must be shorted together with the
supplied jumper plug. Refer to Table 7.2, Page 43, for LED activity.
Microsoft includes Hyper Terminal with the Windows XP operating system and earlier
operating systems.
1.
2.
3.
4.
Bosch Security Systems, Inc.
From your Internet browser, go to http://www.boschsecurity.com to open the Bosch
Web site.
Select the web site for your region and country.
In the Online Catalogs section on the left, click the Intrusion Alarm Systems link.
Under the Intrusion Alarm Systems Products heading, scroll to the Conettix -
Information Transport Solutions section. Click the Show product section link.
CLick the Conettix IP link.
Scroll to the ITS-DX4020-G GPRS/GSM IP Communicator section. Click the section title
to open the product page.
Under the product image, click the Software tab.
Click OK to accept the license agreement.
To the right of ITS-DX4020-G bin, click on the language link (for example, en).
The File Download dialog box opens.
Ensure that the USB-to-mini-USB cable is connected to the ITS-DX4020-G and the target
PC or laptop.
Short the CONFIG MODE jumper pins with the supplied jumper plug.
Start Hyper Terminal by selecting Start>(All)
Programs>Accessories>Communications>Hyper Terminal.
Set up a connection on the new virtual serial COM port (for example, Port: COM4:
ITS-DX4020-G (COM4) using the following settings:
–
Baud rate: 9600
–
Data bits: 8
–
Parity: None
–
Stop bits: 1
–
Flow control: None
To determine which COM port is used by the ITS-DX4020-G:
a.
From your desktop, click Start.
b.
Right-click My Computer, and select Properties.
c.
Select the Hardware tab, and click the Device Manager button.
d.
In the Device Manager list, scroll to Ports (COM & LPT).
Installation and Operation Guide
Firmware Upgrade | en
35
F01U163066 | 01 | 2010.05